9016 00 10 — Balances of a sensitivity of 50 mg or better, with or without weights

9016 Libras of 0.05 g or greater, with or without weights

This heading covers all types of scales, including electronic scales, provided that their sensitivity is 0.05 g or higher. Gigi presented with such weights are classified in this heading, but weights presented separately, even if made of precious metal, are not included (heading 8423). Many types of weights of this heading are intended for precision measurements and are made of noncorrosive metal or light alloys, with knife-shaped support prisms, bearings and agate plates. To protect the scales from air currents and dust, they can be enclosed in a glass or plastic case or embedded in a cabinet consisting mainly of glass or plastic; then they are manipulated using handles and other devices located outside the cabinet. They may also be provided with an optical device (e.g., a magnifying glass), artificially illuminated to facilitate the reading of the scale, or may be provided with devices for horizontal position (triped, adjustable screws, alcohol level, etc.). In some torsion scales, the measured mass is balanced by wire torsion. Some electronic scales operate in vacuum or under controlled pressure to record changes in the mass of the substance subjected to special treatment (heating, cooling, gas, vacuum treatment, light exposure, etc.). The change in mass is measured by recording the current passing through the balancing solenoid. (1) Analytical scales (e.g., microchemical scales, microweights, aperiodic analytical scales) used principally in quantitative chemical analysis. (2) Assay scales used in assay analysis of precious metals. (3) Libras for precious stones graded in carats. (4) Chemistry scales, yarn scales, sample scales (used to determine the weight of paper, textile material, etc.). (5) Hydrostatic balances (or weights for determining specific gravity) for determining the specific gravity of liquids or solids. Subject to the provisions of Notes 1 and 2 to this Chapter (see general provisions), parts and accessories (including fitted or unidentified agate support prisms, bearings and plates) identifiable as being suitable for use solely or principally with weights from this heading also fall within this heading (e.g., peg, cup, housing, limbs, dampers).

However, monopores, d vunogues, tripods and the like, even if they are specifically designed for the apparatus of this heading, are not included (heading 9620). Scales of sensitivity less than 0.05 g are not included in this heading (heading 8423).

Notes

Machine translation. The original is the Russian text of the EAEU tariff, and customs goes by it; this translation is for understanding only and has no legal force.

1. This group does not include:

(a) articles used in machinery, appliances or for other technical purposes, made of vulcanised rubber other than hard rubber (heading 4016), natural or composite leather (heading 4205) or textile material (heading 5911);

(b) support belts or other supporting articles of textile materials, the purposeful effect of which on the supported or fixed organ is only due to their elasticity (for example, bandages for pregnant women, chest bandages, abdominal bandages, joint or muscle locks) (Section XI);

(c) refractory articles of heading 6903; ceramic articles for laboratory, chemical or other technical purposes of heading 6909;

(d) optically raw glass mirrors of heading 7009 or of base or precious metal mirrors other than optical elements (heading 8306 or Chapter 71);

(e) the goods of heading 7007, 7008, 7011, 7014, 7015 or 7017;

(f) parts of general use referred to in Note 2 to Section XV of base metals (Section XV) or similar products of plastics (Chapter 39); however, articles specifically intended for use exclusively in implants used in medicine, surgery, dentistry or veterinary medicine are to be classified in heading 9021;

(ж) насосы с измерительными приборами товарной позиции 8413; счетное или контрольное оборудование, приводимое в действие силой тяжести взвешиваемого груза, или поставляемые отдельно разновесы для весов (товарная позиция 8423); подъемное или погрузочно-разгрузочное оборудование (товарные позиции 8425 – 8428); машины всех видов для резки бумаги или картона (товарная позиция 8441); приспособления для регулирования положения обрабатываемых деталей или инструмента на станках или водоструйных резательных машинах товарной позиции 8466, включая приспособления с оптическими элементами для считывания показаний приборов (например, «оптические» делительные головки), но за исключением тех устройств, которые сами по себе являются исключительно оптическими приборами (например, юстировочные телескопы); счетные машины (товарная позиция 8470); клапаны и другая арматура товарной позиции 8481; машины и аппаратура (включая аппаратуру для проецирования или нанесения рисунка маски на сенсибилизированные полупроводниковые материалы) товарной позиции 8486;

(з) прожекторы или фары, используемые на велосипедах или моторных транспортных средствах (товарная позиция 8512); портативные электрические фонари товарной позиции 8513; кинематографические аппараты для записи, воспроизведения или повторной записи звука (товарная позиция 8519); звуковые головки (товарная позиция 8522); телевизионные камеры, цифровые камеры и записывающие видеокамеры (товарная позиция 8525); радиолокационная аппаратура, радионавигационная аппаратура или радиоаппаратура дистанционного управления (товарная позиция 8526); соединители для волокон оптических, волоконно-оптических жгутов или кабелей (товарная позиция 8536); цифровые аппараты управления товарной позиции 8537; лампы герметичные направленного света товарной позиции 8539; волоконно-оптические кабели товарной позиции 8544;

(ij) floodlights or headlights of heading 9405;

(k) articles of Chapter 95;

(l) monopores, bipeds, tripods and similar articles of heading 9620;

(m) volume measuring tanks classified by the material from which they are made; or

(n) coils, reels or similar carriers (which are to be classified according to the material of which they are made, for example, in heading 3923 or in section XV).

2. Subject to the provisions of Note 1, parts and accessories to machinery, apparatus, tools or articles in this Chapter shall be classified according to the following rules:

(a) parts and accessories which are goods falling in one of the headings of this Chapter or of Chapter 84, 85 or 91 (other than heading 8487, 8548 or 9033) are in all cases classified in the relevant headings;

(b) other parts and accessories intended to be used exclusively or principally in a particular type of machine, tool or apparatus or in several machines, tools or apparatus falling under the same heading (including machinery, tools or apparatus of heading 9010, 9013 or 9031) are included with those machines, tools or apparatus;

(c) all other parts and accessories fall in heading 9033.

3. Notes 3 and 4 to section XVI also apply to this chapter.

4. Heading 9005 does not include telescopic sights for mounting weapons, telescopic periscopes for submarines or tanks, or sight-tubes fitted to machines, devices, instruments or apparatus of this Chapter or Section XVI; such telescopic sights and sight-tubes are classified in heading 9013.

5. Measuring or control optical devices, devices or machines which, but for this note, could be included in both heading 9013 and heading 9031 are classified in heading 9031.

6. For the purposes of heading 9021, the term “orthopedic devices” means devices for:

prevention or correction of bodily deformities; or

Supporting or fixing body parts after illness, surgery, or injury.

Orthopedic appliances include shoes and special insoles made for the correction of orthopedic conditions, provided that they are either (1) made to order standards, or (2) mass-produced, represented by one object and not in pairs and designed to be equally suitable for any foot.

7. Heading 9032 covers only:

(a) instruments and devices for the automatic control of the flow rate, level, pressure or other variable parameters of liquids or gases, or for the automatic control of temperature, whether or not their action is based on an electrical phenomenon varying according to the parameter to be regulated, which are designed to bring this parameter to the desired value and to keep it stable against disturbances, constantly or periodically measuring the actual value; and

(b) automatic regulators of electrical quantities and devices or devices for the automatic regulation of non-electrical quantities, the operation of which is based on an electrical phenomenon varying depending on the parameter to be regulated, which are designed to bring this parameter to the desired value and keep it stable from disturbances, constantly or periodically measuring the actual value.

Additional note

Machine translation. The original is the Russian text of the EAEU tariff, and customs goes by it; this translation is for understanding only and has no legal force.

1. Термин «электронные» в подсубпозициях 9015 10 100 0, 9015 20 100 0, 9015 30 100 0, 9015 40 100 0, 9015 80 110 0, 9015 80 190 0, 9024 10 110 0, 9024 10 130 0, 9024 10 190 0, 9024 80 110 0, 9024 80 190 0, 9025 19 200 0, 9025 80 400 0, 9026 10 210 0, 9026 10 290 0, 9026 20 200 0, 9026 80 200 0, 9027 10 100 0, 9030 20 910 0, 9030 33 100 0, 9030 89 300 0, 9031 80 320 0, 9031 80 340 0, 9031 80 380 0 и 9032 10 200 0 означает приборы и аппараты, которые включают в себя одно или несколько изделий товарной позиции 8540, 8541 или 8542. Однако это не должно относиться к изделиям товарной позиции 8540, 8541 или 8542, функцией которых является исключительно выпрямление тока или которые входят в состав блока питания приборов или аппаратов.